Producten
Instrumental analysis (carbon/sulphur, EOX, AOX, ..)
Complete systems for the measurement of sulfur and carbon, or in combination can be measured by our CS-series, which is using a NDIR or coulometric technique for the detection. Direct link with an analytical balance will exclude typing errors. Specifically for the steel industry is a coulometric detection developed which has a range from 5 ppm to 100% with an accuracy of 0.5 ppm.
The CL10 suitable for measuring halogens (AOX, EOX, POX and TOX) in liquids and solids is equipped with a specially designed oven. This oven can be set with two different heating zones, so liquids can be controlled evaporated. In addition to this, it is possible to set an interval with a 5 degrees temperature gradient. The method is consistent with the ASTM D 4929-99 and the EPA 9076.
The CL10 suitable for measuring halogens (AOX, EOX, POX and TOX) in liquids and solids is equipped with a specially designed oven. This oven can be set with two different heating zones, so liquids can be controlled evaporated. In addition to this, it is possible to set an interval with a 5 degrees temperature gradient. The method is consistent with the ASTM D 4929-99 and the EPA 9076.
 |
 |
 |
 |
The great advantage of our AOX preparation equipment is very user-friendliness. Your sample goes through two pre-packed carbon filter colomns. Both carbon filter colomns, including the absorbed sample are burned in our special oven. Compared to the "shaking method" it will save you much time and washing liquids.
The analysers are served with the highly flexible and user-friendly software that enables customers to view all data and trend lines in a single glance.
Brochures
CL10 (106 kB)
CS50HT (249 kB)
IRF (105 kB)